Simple Canon Robes, Sewing - Wizard Wear - Student Uniforms - Robes |
 Aug 27 2007, 11:44 PM
Post
#1
|
|
Thick Woolen Sock Knitter!  Posts: 521 Joined: 8:28pm October 13, 2005 Location: Oklahoma   |
Simple Canon Robes © Derek Whitten Supplies Fabric (see "Fabric Tips" for notes) Sewing machine Thread Scissors Chalk Iron Fabric Tips When selecting fabric, it is best to avoid man made materials, such as nylon, as these become easily charged with static electricity. Also, a material that is easy to wash and requires minimal ironing is also an advantage. Most importantly, the fabric should be a free flowing fabric that will hang nicely. An assistant at the shop can help find an appropriate fabric, if need be. The fabric will need to be approximately 5 feet (150 cm) wide. For a better fitting robe and if the fabric comes in a larger width, measure the distance from wrist to wrist across the chest and purchase fabric of that size. The length of fabric required is double the shoulder height, plus a few extra inches (centimeters) for a hem. Instructions Folding the fabric It is recommended that the folding and cutting out be done on the floor, as this gives plenty of room to work. Flatten the fabric and fold it in half, making it slightly taller than shoulder height (see Figure A).  Now fold the fabric in half lengthwise (see Figure B).  The fabric will now consist of four layers. It should be as tall as shoulder height, and half the length of the arm span. At this stage, ensure that the fabric is flat, and pin around the edges to hold the layers in place. Taking measurements Before going any further, take the following measurements using the image below, and write them down:  Neck : neck size (the diameter of the neck), divided by 4, minus 0.79" (2 cm) Measurement e-g (see Figure C) : chest/bust plus 9.84" (25 cm), divided by 4 Base : width of folded fabric multiplied by 0.66 Marking and cutting Using the measurements and Figure C above, use a piece of chalk to mark the following:
Cutting it out Pin along the inside of the marked lines. Now, remove the pins from around the outside of the fabric layers. Using a sharp pair of scissors, cut along the line d-e-f and the neckline. Figure D shows what the fabric should look like after unfolding.  Sewing Fold back edges h-i and j-k and press with a hot iron. If the material is two-sided, ensure that the desired outside of the finished product is facing outwards. Sew along both h-i and j-k to hem the ends of the sleeves. Now, fold the material vertically in half again, making sure that the desired outside of the finished product is facing outwards. Using Figure E, sew along p-q-r and repeat on the other side of the robe.  Neckline Turn the robe right side out and try it on. Don't use force at the neck hole, because at this stage it isn't going to fit. This step requires a bit of trial and error. It is best that the neckline comes down lower at the front than the back, so trim 2.5" to 5" (6.35 cm to 12.7 cm) from the front neckline, and a smaller amount from the back. Try the robe again. Repeat this until the head slips through the neck hole easily. After hemming the neckline, it will be even easier. Hem Adjust the length of the robe by putting it on with shoes and asking someone to pin it at the correct lenght. Press the hem with an iron and sew it along l-m and n-o. Alterations to this basic pattern such as a pockets and different colored hems on the base and sleeves may be made. Credit This tutorial was taken with permission from Harry Potter Haven and is based on Meditation Robe pattern of the Servants of the Light. Please note that the patterns and tutorials you find here have been designed by Harry Potter fans all over the Internet. The authors alone hold the copyrights and licences to these patterns and tutorials, which means you CANNOT use their patterns to make something that you will sell to others afterwards. You can use them to make things for yourself. You can make some for your friends and ask them to pay for supplies. You CANNOT, however, ask them to pay you to do it as though you had created this pattern by yourself, or try to sell you crafts to a local store. Think about it. Would you take a Prisoner of Azkaban book, photocopy it, put your name in big red letters on the front cover and try to sell it in your local library? The answer is, obviously, no. Well, selling crafts you have made but not designed would be just as bad! Please note that posting a picture of a finished object on Leaky Lounge will be taken as permission for the photo to be included in the Harry Potter Crafts gallery. If you do NOT wish your photos to be included in this gallery, please PM a Crafty Witch at the time of posting. Also note that the tutorials, recipes and patterns found here have not been tested and that The Leaky Cauldron's Harry Potter Crafts section is not responsible for any mistakes they may contain. If you do find something wrong in one of them, however, please e-mail us to let us know. On that note, Harry crafting to all! This post has been edited by Dragonsinger: Feb 19 2009, 01:40 PM -------------------- Rosemary
 One can never have enough socks. ~Albus Dumbledore |
 |
 
 
|
